Dec 17, 2025 Leave a message

P275N vs P275NH vs P275NL1 vs P275NL2: Selection

EN 10028-3 is the European standard for flat products made of steels for pressure purposes, Part 3: weldable fine grain steels, normalized. The P275 series includes P275N, P275NH, P275NL1, and P275NL2, which share the same base strength but are qualified for different service conditions. In the designation, P indicates pressure vessel steel, 275 is the minimum yield strength in MPa, N means normalized delivery condition, H indicates elevated temperature properties, and L1/L2 indicate low temperature impact quality.

Designation Logic

All four grades are delivered in the normalized condition; the suffixes do not describe different heat treatments but different guaranteed properties. P275N is the room temperature quality. P275NH adds elevated temperature properties, which makes it suitable for components operating at higher design temperatures where the EN 10028-3 high-temperature yield values apply. P275NL1 is the low temperature quality with guaranteed impact energy of 27 J at -40°C, and P275NL2 is the special low temperature quality with 27 J at -50°C. Choosing the correct quality depends on the minimum design metal temperature of the equipment.

Mechanical Properties

For thickness up to 16 mm, all four grades require a minimum yield strength of 275 MPa; the value decreases with thickness (for example 255 MPa for 60-100 mm). The tensile strength range is 410-560 MPa. Charpy V-notch impact requirements: P275N is tested at room temperature (27 J typical), P275NH at elevated temperature quality per standard tables, P275NL1 at -40°C with 27 J minimum, and P275NL2 at -50°C with 27 J minimum. The actual values must be taken from the current EN 10028-3 tables for the relevant thickness and product analysis.

Application Comparison

P275N is the standard, cost-effective choice for pressure vessels, tanks, and heat exchangers operating at ambient temperature. P275NH is selected for boilers and thermal pressure equipment where elevated temperature design strength is needed. P275NL1 suits cold-region vessels and equipment subject to moderately low design temperatures. P275NL2 is used for Arctic, offshore, and LNG-related pressure vessels where the minimum design metal temperature approaches -50°C.

Practical Selection Factors

When choosing among the four grades, consider: the minimum design metal temperature (which drives the L1/L2 choice), the maximum operating temperature and pressure (which drives the H choice), environmental conditions, safety requirements, and budget and availability. Because all four grades have the same base strength and weldability, the deciding factor is almost always the temperature requirement. Impact testing and certification per EN 10204 (typically 3.1) should be specified in the order.

Frequently Asked Questions

Q1: What is the difference between P275N and P275NH?

A1: They have the same base strength; P275NH additionally guarantees elevated temperature properties, making it suitable for boilers and thermal equipment.

Q2: What impact temperature does P275NL1 guarantee?

A2: 27 J at -40°C; P275NL2 guarantees 27 J at -50°C.

Q3: What is the yield strength of P275 grades?

A3: Minimum 275 MPa for thickness up to 16 mm, decreasing with thickness per EN 10028-3.

Q4: Are P275 grades weldable?

A4: Yes, they are weldable fine-grain steels with good cold and hot forming properties; follow the approved welding procedure specification.

Q5: Can P275N be used at -40°C?

A5: Not without verification. P275N has no guaranteed -40°C impact energy; use P275NL1 for guaranteed 27 J at -40°C.

Send Inquiry

whatsapp

phone

Email

Inquiry