Application fields and characteristics of CARMO die steel
The CDS1 steel in the CARMO tool steel series is suitable for tool manufacturing with good wear resistance and special toughness requirements. It is widely used in tool manufacturing fields such as blanking and forming dies, rolls, punches, calenders and wire rolling dies, as well as in some types of scissors.
CDS1 Chemical composition:
C carbon: 1.90~2.20
Si Silicon: 0.10~0.60
Mn Manganese: 0.20~0.60
S Sulfur: ≤0.030
P P ≤0.030
Cr Chromium: 11.0~13.0
V Vanadium: ≤0.030
CDS1 factory status: Annealed HB≤230 Heat treatment hardness: 58-61HRC
CDS1 Application: Suitable for all kinds of hardware cold stamping die, as well as large complex punching die bearing greater impact.
CDS1 steel has excellent wear resistance and can maintain good stability under high pressure and high friction conditions, effectively extending the service life of tools. At the same time, the steel has special toughness, which can provide excellent fracture resistance when impacted or squeezed, improving the reliability and safety of the tool.
Because CDS1 steel has good comprehensive properties, it is widely used in the field of tool manufacturing that needs to meet both wear resistance and special toughness. Whether in the metalworking, plastic forming or textile industries, CDS1 steel can meet the needs of high strength and long life of tools.
In short, CDS1 steel, as a material in the CARMO tool steel series, has excellent wear resistance and special toughness, and is widely used in the manufacturing of tools such as blanking die, forming die, roll, punch, calender die and rolling die, and is used in the manufacturing of some scissors.
