Mar 06, 2024 Leave a message

Reforging Of Tool Steel

Under certain conditions. It is reasonable to use rolled profiles to process products directly. Tool steel that needs to be altered in manufacturing still accounts for a considerable proportion. In addition to hot forging forming can reduce cutting and make full use of steel and other reasons, tool steel forging is conducive to improving the internal quality of steel, the role is also mainly reflected in the following aspects.

1) Usually the smaller the cross-section of steel, the larger the forging ratio, the better the metallurgical quality itself. All the tool blanks that need to be changed first and then added by changing satin, the steel with a smaller cross-section should be changed into a larger truncated blank as far as possible, which is conducive to ensuring that the tool steel has better metallurgical quality inside.

China Steel Billet Suppliers

2) The change of forging makes the flow line distribution inside the tool steel more reasonable. For example, if the disk milling cutter is directly machined after blanking steel slightly larger than the outer diameter, it is reasonable to consider the utilization rate of steel and reduce processing costs, but the direction of the central debris arrangement and the direction of carbide segregation are parallel to the cutting edge, that is, in the direction of the maximum force, which is unfavorable to the performance of the use of small specifications if the clean material is changed (upsetting) Flat), then the flow line is radial (radial) distribution, improve the performance of the milling cutter.

China Steel Billet Manufacturers

3) By changing the forging operator may improve the material of the key parts, so that the material of the part with the most severe stress can be improved, so as to greatly improve the life of the tool steel.

China Steel Billet Distributors

4) The heating process of forging considers the role of diffusion annealing. The heating temperature of tool steel during forging can be slightly higher than the heating temperature of ingot breaking, because the in-product and in-product segregation has been significantly improved after billet opening and rolling. The tendency of local melting of steel to silver heating is reduced. The higher the heating temperature, the longer the liu during heat preservation, the more significant the effect of eliminating segregation. Obviously, the die steel in the process of high temperature heating austenite grain growth, like high temperature heating followed by pressure processing, you can refine the quartz grain, if the final forging temperature control is good, after forging cooling method is reasonable, you can suppress the emergence of network carbide, to ensure the RJ workability of steel and the final use of parts are very important, so the final forging temperature of tool steel Trafficking shall be controlled, generally within the scope of Table 3.2.

Send Inquiry

whatsapp

phone

Email

Inquiry