Wear principle and process of wear-resistant steel plate in port dock
With the development of society, the cargo flow of the port terminal is increasing, and the application of wear-resistant steel plates in the port terminal is more and more, such as the common grab ship unloader grab, ship unloader wear-resistant lining plate, ship unloader hopper lining plate, coal terminal wear-resistant gratings, etc., can greatly increase the service life and work efficiency after the use of wear-resistant steel plates. So, let's take a simple look at the wear principle and process of wear-resistant steel plates in port terminals.
The wear principle of the wear-resistant steel plate used in the port terminal, the wear of the wear-resistant lining plate is mainly divided into two types, namely: erosion wear and impact wear. The wear process is divided into three stages:
The first stage is the primary wear, also known as the low wear stage;
The second stage is the stable wear period, also known as the over-wear period;
The third stage is the period of intensified wear, namely the period of high wear.
Among them, the wear degree during the first and third wear is more serious, and the second period tends to be static.
For example, when a wear-resistant steel plate with a hardness of 360HRC is operated, when the hardness of the material is close to 360HRC, the wear-resistant steel plate will suffer gradually increased wear as the hardness of the material increases; When the hardness of the material is roughly the same as or exceeds the hardness of the wear-resistant steel plate, the degree of wear will increase significantly. Only when the hardness of the wear-resistant steel plate is greater than the hardness of the material, the wear condition will not appear.
In addition, the wear of wear-resistant steel plate is a system engineering problem, there are many factors affecting wear, including working conditions (load, speed, mode of movement), lubrication conditions, environmental factors (humidity, temperature, surrounding media, etc.), material factors (composition, organization, mechanical properties), parts surface quality and physical and chemical properties.







