-
Mar 13, 2024Roll-to-Roll Annealing Process for Wear-Resistant Plate CoilsThe roll-to-roll annealing route produces wear-resistant plate coils with fine grains, qualified and uniform performance at low cost. It covers slab soaking at 830 to 900 degC, con -
Mar 13, 2024Heat Treatment of High-Strength Wear-Resistant Steel PlateHeat treatment decides whether a wear-resistant plate reaches its specified hardness and toughness, and the correct cycle depends on whether the plate is carbide-strengthened auste -
Mar 13, 2024Effect of Oxy-Acetylene Thermal Spraying Ni-Based Powder on Q235 Steel Micros...Oxy-acetylene thermal spraying of a Ni-based self-fluxing powder produces a dense modified layer on Q235 steel with only trace porosity and a clear interface with the substrate. Bo -
Mar 13, 2024Effect of Samarium on the Microstructure of AZ61 Magnesium AlloyAZ61 is a heat-treatable wrought Mg-Al-Zn alloy whose properties depend on how much aluminium is held in solid solution and how Mg17Al12 is distributed. Additions of 0.5-2.0% samar -
Mar 13, 2024Wear-Resistant Plate Forgings: Cracking Causes and Heat-Treatment Countermeas...Cracking of wear-resistant plate forgings during quenching and tempering is traced to banded component segregation, residual gases and inclusions, excessive forging temperature and -
Mar 13, 2024Hot Deformation and Dynamic Recrystallization of NM400 Wear PlateSingle-pass hot compression testing maps the deformation window of low-alloy abrasion-resistant plate: peak stress falls with rising temperature and falling strain rate, while comp -
Mar 12, 202450CrMo4 (1.7228) Quenched and Tempered Alloy Steel Plate50CrMo4 (1.7228) is a 0.5 % carbon chromium-molybdenum quenched and tempered steel under EN 10083-3, giving 900-1300 MPa tensile strength depending on section and tempering tempera -
Mar 12, 202410CrMoAL Steel Plate: Composition, Heat Treatment and Welding10CrMoAL is a low-alloy chromium-molybdenum pressure plate with a controlled aluminium addition that refines grain size and improves scaling resistance. This guide covers its desig -
Mar 12, 202430CrMnSiA Alloy Steel Plate: Properties, Heat Treatment and Use30CrMnSiA is a special-quality Cr-Mn-Si alloy structural steel to GB/T 3077, used for gears, shafts and wear parts that need high strength with reasonable toughness. This guide set -
Mar 12, 202442CrMo4 1.7225 Alloy Steel: Composition and Heat Treatment42CrMo4 is a chromium-molybdenum quenched and tempered steel defined in EN 10083-3, with roughly 0.42% carbon, 1% chromium and 0.2% molybdenum. This guide sets out its certified ch -
Mar 12, 202415CrMo5 1.7262 Cr-Mo Steel for High-Temperature Pressure Parts15CrMo5 is a DIN chromium-molybdenum steel used for boiler and pressure vessel components operating up to roughly 550 degrees Celsius. The article covers its certified chemistry, t -
Mar 12, 202441CrMo4 Alloy Steel: Composition, Properties and Heat Treatment41CrMo4 is a chromium-molybdenum structural steel supplied in the quenched and tempered condition for parts that need high strength together with wear resistance and impact toughne




